Palmetto State Armory Dagger™ | Page 12 | Glock Forum - GlockTalk

 

Any trigger for a gen 2-4 Glock 19 will work.
If you are going to get a trigger you can do MUCH better than a OEM Glock trigger!
I went with this one for my Dagger;

PolyDAT Trigger for Glock™

OP is pleased to introduce the first flat-faced aftermarket polymer trigger for you Glock pistol upgrade. With a reduced cost, there's no reason not to upgrade.

overwatchprecision.com

While in there I also installed a Glock "-" connector and did a $0.25 trigger job.

 

For $60 it's worth a shot. Thanks for the responses and info!

 

The stock Dagger shoe feels good but the pull was very gritty so I put an Apex and minus connector in mine.

 

@arndog123 How well does the silencer work on the revolver?

 

I haven’t shot the revolver yet but from what I’ve seen on YouTube it’s not a good suppressor host due to all the gases escaping through the cylinder. Looks like it’s actually louder with a silencer on than without. I’ll know firsthand tomorrow when I shoot it😄

 

I have put an OEM trigger on mine. I like it.

Sent from my SM-T860 using Tapatalk

 

I'm having a weird issue here. I have a dagger frame, and am trying to put an Overwatch DAT trigger in (supposed to be compatible with Glock Gens 1-4). When I put in that trigger, after dry firing it doesn't reset when I pull back the slide, and doesn't generally reset until the slide comes back forward. Further, the slide is locking back when I pull it back, even with no magazine.

I don't even want to try to fire it until I know what's going on, of course. Anyone have any ideas?

 

I'm having a weird issue here. I have a dagger frame, and am trying to put an Overwatch DAT trigger in (supposed to be compatible with Glock Gens 1-4). When I put in that trigger, after dry firing it doesn't reset when I pull back the slide, and doesn't generally reset until the slide comes back forward. Further, the slide is locking back when I pull it back, even with no magazine.

I don't even want to try to fire it until I know what's going on, of course. Anyone have any ideas?

I am not exactly sure how/what happening with that aftermarket trigger, but it sounds like a connector issue.

Thank you,

Josiah