[WinterWizard]

I gave my G21sf a 25cent trigger job.
I noticed no improvement.
I tested my G26 trigger pull against my
G21sf trigger pull and the G26 was much
lighter.
I then read up on this controversial trigger
bar bump and decided to file it off and then
polish it.
This bump removal significantly lightened
the trigger pull and the 45 runs
with no issues.
I'm very pleased.
ron

I had the exact same experience on my G36. $.25 did nothing and filing the bump down about 2/3s of the way took about a lb. off my trigger pull, with absolutely no effect on function.

 

[WinterWizard]

Measure the trigger pull, change to a trigger/trigger bar without the bump and measure again. There Will Not be a 1# reduction in the trigger pull. Your best bet is to polish and lubricate as already stated.

Not everyone's will, but MINE DID. Went from about 7 lbs to about 6 lbs.