[konyo312]

I've been thinking about a Micro Roni. I have a P80 G19 with a Brownells slide and threaded barrel. Anyone know if this setup would be compatible with a Micro Roni?

Sent from my moto e5 cruise using Tapatalk

 

[Preyhunter]

I have the RONI Stab. built for the 17. Even with a P80 frame and threaded barrel, it works. I'd imagine that a similar setup for a 19 would be the same.

This is a RONI Stab, not sure about the Micro. That requires an ATF stamp for a SBR, right?

 

[Mike-M]

FWIW, poly80 threads are considered OT to General Glocking because they are not about Glock pistols. A moderator will transfer this to General Firearms.

 

[stavey]

FWIW, poly80 threads are considered OT to General Glocking because they are not about Glock pistols. A moderator will transfer this to General Firearms.[/QUOT
The only difference is a lower receiver. Which is vastly better than Glock’s. In my opinion. So if I have a lonewolf frame ,I can’t post here ? I think you are mistaken.

 

[konyo312]

I have the RONI Stab. built for the 17. Even with a P80 frame and threaded barrel, it works. I'd imagine that a similar setup for a 19 would be the same.

This is a RONI Stab, not sure about the Micro. That requires an ATF stamp for a SBR, right?

Thanks. That helps a lot. I was also concerned about the slide, but looking at my stock G26, the slide cuts look about the same.

The model I was looking at has an arm brace, and classified as non-NFA.


Sent from my iPad using Tapatalk