[racer88]

So, while my current P80 / G19 build project's frame assembly was on hold while I waited for Rook Tactical rails to come back in stock, I went ahead with the slide assembly, since I had all the upper OEM parts.

Since I had a factory Glock 19 (Gen 2), which was my first pistol ever - purchased in 1992... I had a lower on which I could test my Zaffiri ZPS.EDC slide.

When I pulled the slide all the way back, about half the time, it would stick there. The slide was getting hung up on the barrel. I didn't think to get video of that happening, but I did get video from the point where I began addressing the issue. Enjoy! 7 minutes long. I hope it helps someone!

YouTube deleted. Moved to Rumble. See below:

 

[racer88]

YouTube is deleting all P80 content and channels.

Moved my video here:

Fitting Barrel to Slide P80 / G19

Edit to add: The video gets cut off at 7:00. Not sure why! Stand by. I assembled my slide while I wait for some parts for the frame. I had a factory Glock 19 (Gen 2) that I could test the slide on. Wh

rumble.com

My Rumble channel is here:

Racer88's videos

Browse the most recent videos from channel "Racer88's videos" uploaded to Rumble.com

rumble.com