close

Privacy guaranteed - Your email is not shared with anyone.

trigger bar position

Discussion in 'General Glocking' started by jfrey, May 19, 2011.

  1. jfrey

    jfrey

    Joined:
    Apr 9, 2011
    Messages:
    179
    Likes Received:
    0
    I notice on both my G19 and G36 when I remove the slide, the curved rear end of the trigger bar is to the right and outside the connector. Is this normal or is it a tension problem with the connector? Slightly pushing the trigger bar forward will let it snap back under the connector. Does this happen all the time when firing the pistol too?
     
  2. JR

    JR Moderator Millennium Member

    Joined:
    Dec 29, 1998
    Messages:
    3,057
    Likes Received:
    2
    Location:
    Oldtown Idaho USA
    Yep that is normal.
    Yep, when you push the connector the trigger bar should reset.