Glock Talk banner
121 - 123 of 123 Posts
Discussion starter · #121 ·
Then I guess I've been fortunate as every FL sizing die I have has made contact with either the shellplate or shell holder, bottleneck and straight walled, and from differing manufacturers. Cam-over...

Very well could have been the luck of the draw (or milling machine). Granted, a case gauge is a good idea to have on the bench.
<shrug> for me, my 9mm sizing die goes down to the shell plate, my 223 die crushed the case when I tried that and needed to be backed off a bit.
 
This will get you going in the right direction.
[ame="http://www.youtube.com/watch?v=VRZrbv_8kx4"]How to reload with a Dillon RL 550B Part 1 - YouTube[/ame]
 
121 - 123 of 123 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top