close

Privacy guaranteed - Your email is not shared with anyone.

Discussion in 'Test-Posts Here' started by shadow500, Jan 6, 2007.

Joined:
Dec 6, 2006
Messages:
398
0
Location:
Down the shore
I agree to use the trial and error method with a scale.

If you really want to use the numbers I made a little calculator in Excel.
I cant find a way to post a spreadsheet on this site so I converted it to text. Highlight everything below and copy it directly into Excel. This should result in an operational spreadsheet calculator. Remember that Lees VMD numbers are very conservative and that even after setting to the calculated numbers you will still have to use trial and error with a scale to fine tune.

Hope this helps,

Chris

[Highlight everything below and paste it into Cell A1 if an Excel Spreadsheet]
Enter Powder VMD below
0.1234
Enter desired charge in Grains below
10
Output
Estimated setting in CC (rounded)
=ROUND(A2*A4,2)
Turn to this major number
=ROUNDDOWN(A7,0)
Turn thimble this many extra turns
=(ROUNDDOWN(A7,1)-A9) * 10
Turn thimble extra to this number
=(ROUNDDOWN(A7,2) - ROUNDDOWN(A7,1))*100

2. ### verticalfreak

Joined:
Jan 29, 2007
Messages:
12
0
Location:
Kansas-Near Venomjunkey
what was that?

3. ### verticalfreak

Joined:
Jan 29, 2007
Messages:
12
0
Location:
Kansas-Near Venomjunkey
trying to get my 10 posts in...

4. ### verticalfreak

Joined:
Jan 29, 2007
Messages:
12
0
Location:
Kansas-Near Venomjunkey
I can post...

5. ### verticalfreak

Joined:
Jan 29, 2007
Messages:
12
0
Location:
Kansas-Near Venomjunkey
picture for my avator.

Joined:
Jan 29, 2007
Messages:
12