Sub 2000 mag seat problem

Discussion in 'Kel-Tec Talk' started by dissthis, Feb 8, 2012.

  1. dissthis

    dissthis Gun Fan

    Messages:
    412
    Likes Received:
    0
    Joined:
    Aug 24, 2005
    Location:
    Marietta, GA
    I bought a Sub 2000 that has an issue when you insert the mag...the mag doesn't seat fully...about 1/16'' - 1/8" low...when the bolt moves forward it strips the round off the mag but is too low to enter the feed ramp and the round gets compressed so the bullet gets pushed further into the brass...

    If you hold your pinky under the mag it works fine...but...who wants to do that....

    its a Glock 9mm set up and the previous owner cut the grip down to accept G19 mags...I don't think this home gunsmithing is the cause as the mag catch is higher in the grip...

    Any ideas? Should I send it back to Keltec?

    Thanks
     
  2. shoremnj

    shoremnj sparare

    Messages:
    14
    Likes Received:
    0
    Joined:
    Jan 2, 2012
    Location:
    Near Sandy Hook, NJ
    You can try sending it back but the grip was cut and may void any warranty.