close

Privacy guaranteed - Your email is not shared with anyone.

Strike Hold

Discussion in 'Gunsmithing' started by mclaren, Feb 12, 2010.

  1. mclaren

    mclaren

    Messages:
    174
    Likes Received:
    1
    Joined:
    Dec 10, 2009
    I hope this is the appropriate place to post. It relates to Gunsmithing in that it prevents costly refinishing.
    Anyone every use Strike Hold? I have an aerosol can from a gun show. I had serious corrosion problems with my 1911 until I applied this. The corrosion was one thing that drove me to Glock, never have to worry about it. I was about to give up on the beloved .45 when I found this stuff. It stopped corrosion dead in its tracks. I had never heard of it until a friend gave me a can. I use it on all my guns now. Water beads on it like wax.
    Just wanted to pass along the helpful info and see if anyone else has had these great results.
     
  2. MSgt Dotson

    MSgt Dotson

    Messages:
    3,268
    Likes Received:
    11
    Joined:
    Sep 30, 2006
    Alas, I've never heard of it...
     

  3. 125K9

    125K9

    Messages:
    1,308
    Likes Received:
    374
    Joined:
    Dec 22, 2009
    Location:
    East TX for now. Home: Lookout Mtn., AL
    After I've cleaned my Glock I spray the insides with Strike Hold. For the higher stress points I use Weapon Shield. I've used Strike Hold for 6-7 years with very good luck, but I wouldn't use it for things like the rails, connector, etc.
     
  4. kat1950

    kat1950

    Messages:
    706
    Likes Received:
    0
    Joined:
    Aug 25, 2006
    Location:
    seminole county, florida
    Military has been using for years, it is a great product.