close

Privacy guaranteed - Your email is not shared with anyone.

Stock Glock Recoil Spring On SS Guiderod?

Discussion in 'General Glocking' started by rockinglockin, Jul 28, 2002.

  1. rockinglockin

    rockinglockin Young Geezer

    Messages:
    157
    Likes Received:
    0
    Joined:
    Oct 17, 2000
    Location:
    Southland
    Has anyone used a Glock recoil spring on a captured stainless steel guiderod? If so, did you encounter any problems? Thanks in advance for any replies.
     
  2. WalterGA

    WalterGA Millennium Member

    Messages:
    3,742
    Likes Received:
    0
    Joined:
    Jan 26, 1999
    I have; no problems.
     

  3. SIX14LIFE

    SIX14LIFE TACTICAL G19'S

    Messages:
    654
    Likes Received:
    0
    Joined:
    Mar 24, 2002
    Location:
    MOUTH OF THE RAT,FLA.
    That is perfectly fine.
    Make sure it is not to old and worn out.
    Replace w/either wolf or IMSI flatwire springs.:)
     
  4. ryucasta

    ryucasta IDPA/IPSC Cuban

    Messages:
    598
    Likes Received:
    0
    Joined:
    Feb 21, 2002
    Location:
    Ventura County Cailfornia
    It all depends on the model Glock. I experienced problems with the G34 and the G35 when using the original spring with the SS and tungsten guide rods. I actually had to go to a 13 pound spring on the G34 and a 15 pound spring on my G35 that due to the fact that the gun wouldn’t cycle properly. I didn’t experience any problems though with the G17 or G22.