close

Privacy guaranteed - Your email is not shared with anyone.

Slide on frame without barrel

Discussion in 'General Glocking' started by .357Magnus, May 27, 2010.

  1. .357Magnus

    .357Magnus

    Messages:
    88
    Likes Received:
    0
    Joined:
    Sep 28, 2006
    Location:
    Gone Fishin'
    Hi,
    I made the mistake of putting my glock Slide on frame the frame without the barrel. After I pulled it back, it became stuck there. I lined up the slide on top of the frame and pulled the trigger. This released the slide to come off. All seems fine with a function check. Could I have done any damage doing this? Are there particular parts I should check for damage?
    Many thanks,
    Magnus
     
  2. JR

    JR Moderator Millennium Member

    Messages:
    3,058
    Likes Received:
    2
    Joined:
    Dec 29, 1998
    Location:
    Oldtown Idaho USA
    No problem, no worries. You did exactly what needed to be done to remove the slide. Simply push the slide flush with the frame and pull the trigger. The slide will pop forward about an inch and then slide right off the frame.
     

  3. .357Magnus

    .357Magnus

    Messages:
    88
    Likes Received:
    0
    Joined:
    Sep 28, 2006
    Location:
    Gone Fishin'
    Thanks very much for the reply. Hope you have a good holiday weekend.