close

Privacy guaranteed - Your email is not shared with anyone.

slide locking issues

Discussion in 'General Glocking' started by motorjon68, May 28, 2011.

  1. motorjon68

    motorjon68

    Joined:
    May 28, 2011
    Messages:
    23
    Likes Received:
    0
    Location:
    Milford, Ohio
    I'm sure this has been addressed, but the terms are so common that tons of stuff comes up when I search. I apologise. Anyway, the slide on my 26 locks back in place even when there isn't a mag in. I noticed that the slide release is 'up' and not down like it should be. Any ideas? thx, Jon
     
  2. JR

    JR Moderator Millennium Member

    Joined:
    Dec 29, 1998
    Messages:
    3,054
    Likes Received:
    2
    Location:
    Oldtown Idaho USA
    You installed it incorrectly. Take it back out and reinstall again. Locking block pi first, trigger pin second, make sure the spring is UNDER the locking block pin!