[dla]

Made in Argentina. Run OK in my Dillon SDB. Loaded some in 9mm and they went bang, but only tried about 15 through one pistol.

I was wondering if someone else had used them and could share their experience.

 

[RBRK]

They load and seat fine but cups seem to be on the hard side. Some take a few hits in striker guns to go off I would say up to 5/100 at times. Hammer fired guns I’ve never had issues.

 

[dla]

The few I shot were through a hammer-fired pistol (PF9) and they seemed to make a decent indent on the primer. I'll try them later through a G19 and a DVG-1.

 

[SkippyKustoms]

I’m so tempted to order some but would hate for them not to function in my Glocks.


Sent from my iPhone using Glock Talk mobile app

 

[fredj338]

They load and seat fine but cups seem to be on the hard side. Some take a few hits in striker guns to go off I would say up to 5/100 at times. Hammer fired guns I’ve never had issues.

If they are firing 95% of the time, push a bit harder during seating. Hard primers are often more diff to seat to the bottom of the pocket.

 

[collim1]

I would buy some of the price is right. I have a W German P226 I have no doubt would set em off.

 

[21 shooter]

They ran fine in a stock Glock 19. Hard primer, need extra attention to seating them. Accuracy same as Win/Fed/CCI. They are much better than no primers at all.

 

[smartShooter]

I bought some. Had no problems shooting them in my Beretta. Don't think I've tried them in a Glock yet though