Glock Forum - GlockTalk banner
1 - 6 of 6 Posts

·
M62/76
Joined
·
13,160 Posts
Discussion Starter · #1 ·
I am acquiring a Rem 40X that I’d like to convert to a single-shot and am wondering if any of you folks have experience with this? Should I have a gunsmith install a block into the well of the gun or is there a clip I can get to block off the magazine? Any info is appreciated.
 

·
M62/76
Joined
·
13,160 Posts
Discussion Starter · #5 ·
Thanks for the great info guys, looks like problem solved!
 

·
Registered
Joined
·
1,085 Posts
My 2 are a 6BR cal and 6 mm Ackley Imp. It is a 5 minute fitting job and overnight epoxy dry time plus just knock it out and go back to repeater any time you wish to, the part should run about $6-8. NOTE: they fit so well not all need fitting just tap in and epoxy.
 
1 - 6 of 6 Posts
Top