Glock Talk banner

Problem with Talon Grips on my 19.4

1484 Views 12 Replies 6 Participants Last post by  azks804
I was about to put on a set of Talon granular grips on my G19.4 and I stopped before I removed the backing. I realized the grips are designed for applying to the stock Glock grip. I use the large beavertail on my 19 because that’s what makes my 19 comfortable, and I’m not about to do without it. If I put the Talon grip over the beavertail, (1) it might not fit right, and (2) I’d run into a big problem if I needed to remove the beavertail for a detail strip or something.
Am I missing something? What are my options? What if I just cut the Talon grip so the backstrap part is separate?
1 - 1 of 1 Posts

· Registered
362 Posts
Check and see if the Talon Grips are not offered in sizes to fit the Gen4 guns specifically for the back strap used (or no back strap). Not a one size fits all if memory serves me.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.