Glock Forum - GlockTalk banner
1 - 3 of 3 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
Hi all, I have a recently built p80 g19, and am encountering some issues, wondering if anyone has dealt with this. In order to rack my slide properly and have it go fully into battery I have to push down on the chamber and "seat" the barrel. It will usually get stuck, at which point I have to lift up on the tip of the barrel for it to go into battery. If i do it fast and hard it's ok 50% of the time. When the gun is cleared and held open the barrel has a lot of wiggle and play. Any suggestions?
 

·
Have Gun Will Travel
Joined
·
3,456 Posts
I don't know if one exists - but if it does, a P80 forum might be more help for you.

It sounds to me like tolerance stacking. You have a number of parts fitting together. They are all (presumably) made to a specific spec but may be at the edge of the specification range. When they are all combined, those numbers add up and you run into geometry problems. Hopefully someone else will have some more helpful info for you. Good luck.
 

·
Registered
Joined
·
3 Posts
Discussion Starter · #3 ·
I don't know if one exists - but if it does, a P80 forum might be more help for you.

It sounds to me like tolerance stacking. You have a number of parts fitting together. They are all (presumably) made to a specific spec but may be at the edge of the specification range. When they are all combined, those numbers add up and you run into geometry problems. Hopefully someone else will have some more helpful info for you. Good luck.
Ok thanks. Couldn't find a p80 forum, figured I'd give it a shot.
 
1 - 3 of 3 Posts
Top