close

Privacy guaranteed - Your email is not shared with anyone.

Possible locking block problem?

Discussion in 'General Glocking' started by Meathead9, Aug 27, 2010.

  1. Meathead9

    Meathead9

    Messages:
    1,207
    Likes Received:
    13
    Joined:
    Aug 23, 2009
    Location:
    The PRK
    I was field stripping my G20L to clean it after a range trip, and I noticed some daylight between the bottom/forward part of the locking block and the frame. Also the top of the locking block isn't flush with the frame either. I disassembled it, put in new pins, and it's still the same. Hopefully I just never noticed this before, but is this normal? I know pics would help, but I don't have any right now.

    It still functions perfectly, I just want to make sure everything is as it should be before I start throwing parts at it. I'm just hoping it's not a frame issue.
     
  2. JR

    JR Moderator Millennium Member

    Messages:
    3,057
    Likes Received:
    2
    Joined:
    Dec 29, 1998
    Location:
    Oldtown Idaho USA
    If the gun functions reliable and groups normal I would not suspect anything is wrong with the frame.
    FYI: Some of the slides tend to ride a little high on the frame.