Glock Talk banner

Polymer 80 Barrel Issue

17370 Views 57 Replies 17 Participants Last post by  JAA
Completed a Polymer 80 build ie Glock 19 Gen 3without issues. After successfully putting 30 rnds down range cleaned gun. Noticed that there were gouge marks on each side of the barrel near the breach area that contacts the locking block. Put another 60 rnds through with no discernible difference in the gouges. Has anyone else experienced this issue?
Look forward to your thoughts
1 - 1 of 1 Posts
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top