GlockTalk Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
131 Posts
Discussion Starter #1
Hi,

This is a G17 Gen5 frame with a compact ADE HG54 laser attachment on its rail.
Frame is used with either stock G17 iron sights or shown below G34 MOS slides.

I need a holster that would fit both OK, ideally, mostly for a range use, but, if it it would work acceptably OK for a CCW - why not. Price is less a factor than a convenience.

Obviously - the laser sight is in the way, somewhat, and does not fit well into most regular holsters. Any ideas would be greatly appreciated.

G34 MOS DP_Pro_2.5.jpg
 

·
Registered
Joined
·
131 Posts
Discussion Starter #2 (Edited)
Well, it`s too bad no one has anything to respond...

I received this one so far and it`s pretty horrible.
https://www.amazon.com/gp/product/B084D9FFYX
- ordered a version for TLR1 attachment, and, perhaps it would work with TLR1 OK, but, with this little laser gun has a tendency to get into the hoster a bit sideways and gets stuck on an entry, not good at all.

i ordered 4 more different versions from amazon, hoping this one may actually work - but, not sure.
So, will try those:
https://www.amazon.com/gp/product/B004ML5V3O
https://www.amazon.com/gp/product/B072FN4WGZ
https://www.amazon.com/gp/product/B010TRN18G
https://www.amazon.com/gp/product/B01GUQQUYC
 

·
Registered
Joined
·
131 Posts
Discussion Starter #3
So,

from now almost 10 holsters i saw - this one is the winner:
https://smile.amazon.com/gp/product/B004ML5V3O

it does not obstruct the red dot too much and slides in and out very nice. good for draw practice. almost none of others would let gun in or out without issues.

Probably it would be nice to make a good custom made one, but, i will wait to see how this laser will behave. for now it was keeping zero fine and a joy to use, so, will keep it as is.
 
1 - 5 of 5 Posts
Top