close

Privacy guaranteed - Your email is not shared with anyone.

Newbie needs help, sights.

Discussion in 'Sights, Optics and Lasers' started by orthodoc, Dec 3, 2012.

  1. orthodoc

    orthodoc

    Joined:
    Dec 3, 2012
    Messages:
    4
    Likes Received:
    0
    Had a new G-19 at the range last week. First shots were not on the paper. Point of impact is low and way right. I can drift the rear sight for windage, but I need to do something about elevation. I came home and measured my rear sight. I have seen sights in the range from 6.3 to 7.3 mm. on a popular auction sight. I did not know where to measure the sight, but from the top of the slide to the top of the sight appears to be 6.5mm. Is that the standard sight for a Gen 4 G19? I do not mind buying a sight, but I would prefer to stay with the standard Glock sight. Anyone have any good solutions for my problem? I am just a casual shooter, if I can keep them all in a foot at 50 ft., I am satisfied.
     
  2. phonejack

    phonejack

    Joined:
    Jun 28, 2009
    Messages:
    584
    Likes Received:
    81
    Location:
    arkansas
    There are some that will disagree with this, but the POA will change after it is broken in.
     

  3. 4Rules

    4Rules

    Joined:
    Mar 11, 2012
    Messages:
    2,911
    Likes Received:
    188
  4. orthodoc

    orthodoc

    Joined:
    Dec 3, 2012
    Messages:
    4
    Likes Received:
    0
    Once again, I will ask, how does one measure the height of the Glock factory rear sight?
     
  5. 4Rules

    4Rules

    Joined:
    Mar 11, 2012
    Messages:
    2,911
    Likes Received:
    188