Glock Forum - GlockTalk banner
1 - 8 of 8 Posts

·
Registered
Joined
·
3,085 Posts
Discussion Starter · #1 ·
If ya don't know bud out. I've watched as many vids as possible but nothing detail about my predicament. Just disassembled my 19X and don't know the proper position the little rod goes back into the bar with the trigger spring (part 25). I unfortunately didn't notice it was angled on one side before disassembly; I did notice after reassembled. Does the angle go up or the flat side go up? Help!
 

·
Banned
Joined
·
6,833 Posts
If ya don't know bud out.
Well, "Bud", one thing that many do know is, outside educational purposes, there's no point to removing the trigger spring assembly from the trigger mechanism housing of a Gen5 pistol, and then disassembling even that. :)

The whole TMH/ejector/trigger spring assembly for Gen5 and G42/43 pistols is sold as one integral part.
 

·
Registered
Joined
·
3,085 Posts
Discussion Starter · #6 ·
1 - 8 of 8 Posts
Top