close

Privacy guaranteed - Your email is not shared with anyone.

My gen4 g34 ! ....well sorta

Discussion in 'General Glocking' started by scubadds, Aug 26, 2010.

  1. scubadds

    scubadds

    Messages:
    13
    Likes Received:
    0
    Joined:
    May 23, 2010
    I've seen conflicting advice
    I have a g34 slide with Barsto barrel but don't have a lower for it.

    I tried it on my g17 gen 4 lower and it seems to fit fine and dry fire tests seem normal.

    Has anyone done similar with no problems?

    Just double checking before I fire it and cause any problem
     
  2. JR

    JR Moderator Millennium Member

    Messages:
    3,058
    Likes Received:
    2
    Joined:
    Dec 29, 1998
    Location:
    Oldtown Idaho USA
    Yah it works if you use the Gen3 recoil spring. The only issue is cosmetic: there is a gap between the frame & slide at the forend.
     

  3. scubadds

    scubadds

    Messages:
    13
    Likes Received:
    0
    Joined:
    May 23, 2010
    I saw that but it is hardly noticable with the long slide
    Great!
    Just didn't want to make a mistake, I have a 3 gun match Sunday
     
  4. JR

    JR Moderator Millennium Member

    Messages:
    3,058
    Likes Received:
    2
    Joined:
    Dec 29, 1998
    Location:
    Oldtown Idaho USA
    Your always better off testing new equipment at the range. This way you can take your time to overcome any issues if the pop up. If you make the changes and then attend a match it could cost you a class.