Glock Forum - GlockTalk banner
1 - 6 of 6 Posts

·
Registered
Joined
·
85 Posts
Discussion Starter · #1 ·
Hey gang- Have a Gen III G19 with TruGlo night sights. Pistol got bumped around today, and now the front sight is loose. It appears that the front sight has a pin that holds it in- it is not a screw head on the inside of the slide. What is the right way to go about tightening this? Appreciate any help, thanks!!!
 

·
Banned
Joined
·
6,280 Posts
If it's loose it means one of two things:


A. it was never properly Loctited

B. you hit it very hard.


Who installed it? You need a nut driver and some Blue Loctite:

[ame="http://www.youtube.com/watch?v=R4MG0teQuBA"]TruGlo FO Sight Installation - YouTube[/ame]
 

·
Registered
Joined
·
100 Posts
So you are saying there there isn't the regular sight screw on the bottom of sight on the slide? I've never seen that, could it be possible it was smacked hard enough to break off the screw head?
 

·
Retired Member
Joined
·
9,198 Posts
Some early Glock sights, including night sights, were staked on or pinned on, no screws involved. :shocked:

--Ray
 
1 - 6 of 6 Posts
Top