close

Privacy guaranteed - Your email is not shared with anyone.

loose trigger safety pin?

Discussion in 'General Glocking' started by unclecharlie, Oct 10, 2011.

  1. unclecharlie

    unclecharlie

    Joined:
    Sep 17, 2009
    Messages:
    173
    Likes Received:
    0
    Was cleaning my Gen3 G23 last night after a pleasant afternoon of shooting and noticed that the pin through the trigger (that the trigger safety rotates on) was a little bit proud. It just sort of popped loose, I guess. Not completely out, just poking from the side of the trigger a little.

    No problems shooting (thinking back, I might have noticed a little stubbornness in the trigger safety), and it popped right back in place, but I wonder if anyone has ever had an issue with this before?

    Would hate for the trigger safety to disassemble itself and put my carry piece out of commission when I need it most.

    -Charlie
     
  2. JR

    JR Moderator Millennium Member

    Joined:
    Dec 29, 1998
    Messages:
    3,054
    Likes Received:
    2
    Location:
    Oldtown Idaho USA
    This is the first I have ever heard of the safety pin working loose? I advise you replace the trigger w/trigger bar and be done with it.
    FYI: If the pin were to fall out, the safety would fall away and the trigger would still work.
     

  3. unclecharlie

    unclecharlie

    Joined:
    Sep 17, 2009
    Messages:
    173
    Likes Received:
    0
    Thanks. Will get on that.

    Good to know it won't stop it from functioning.

    -Charlie