Glock Talk banner
1 - 7 of 7 Posts

· Registered
Joined
·
189 Posts
Discussion Starter · #1 ·
I just picked up a box at Sportsmans but cannot find ANY data on the 200 gr HSM load. I found plenty of info on the 180's but nothing on the 200, is it a new offering? It's in a black box which indicates that it's new not reloaded I think. Box says "10MM 200 Grain FMJ". Anybody?
 

· Ret. Fireman
Joined
·
4,603 Posts
Nothing on the official HSM site! only 180gr and remanufactured 180gr. Oh well call or write them directly...
 

· Registered
Joined
·
189 Posts
Discussion Starter · #4 ·
Shot them this weekend and they seem pretty hot. Did an alernating bullet mix in one mag with some Buffalo Bore 180's and the HSM 200's and recoil was about the same and all the brass had the Glock bulge and primers had the rectangle mark from the firing pin channel which you normally dont see from "normal" off the shelf ammo. Without chronoing them I'm not sure but for $25-$30 per 50 these are the only cheapish 10mm I have found that feels like a real 10mm load.
 

· 10mm Philosopher
Joined
·
6,640 Posts
Shot them this weekend and they seem pretty hot. Did an alernating bullet mix in one mag with some Buffalo Bore 180's and the HSM 200's and recoil was about the same and all the brass had the Glock bulge and primers had the rectangle mark from the firing pin channel which you normally dont see from "normal" off the shelf ammo. Without chronoing them I'm not sure but for $25-$30 per 50 these are the only cheapish 10mm I have found that feels like a real 10mm load.
Linky? :cool:
 

· Registered
Joined
·
189 Posts
Discussion Starter · #6 · (Edited)

· 10mm Philosopher
Joined
·
6,640 Posts
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top