close

Privacy guaranteed - Your email is not shared with anyone.

GunKote a Glock frame????

Discussion in 'General Glocking' started by GlennS, Aug 28, 2003.

  1. GlennS

    GlennS

    Messages:
    35
    Likes Received:
    0
    Joined:
    Jan 31, 2003
    Location:
    Alabama
    Some of the GunKote type coverings say it can be used on plastic and polymer. Can the Glock frame withstand the 250-300 degree heat needed to cure the GunKote? It has to bake at 300 degrees for 1 hour to full cure.
     
  2. GlocksterJeff

    GlocksterJeff Glock Armorer

    Messages:
    678
    Likes Received:
    0
    Joined:
    Jun 29, 2003
    Location:
    'Sunny' Oregon

  3. GlennS

    GlennS

    Messages:
    35
    Likes Received:
    0
    Joined:
    Jan 31, 2003
    Location:
    Alabama
    Yep, I found that last last night. Saw a picture of an OD Green Glock frame. Looked pretty good too and it was DuraCoat. I wondered how the wearability is. Sounds like it is easier to apply and cure than GunKote. I will probably give it a try. When I do I'll post the results here.
     
  4. APOLLO

    APOLLO IDPA Member

    Messages:
    180
    Likes Received:
    0
    Joined:
    Aug 25, 2003
    Location:
    U.S of A
    Be very careful !