close

Privacy guaranteed - Your email is not shared with anyone.

Glock slide machining?

Discussion in 'General Glocking' started by Tspeis, Aug 9, 2004.

  1. Tspeis

    Tspeis

    Messages:
    37
    Likes Received:
    0
    Joined:
    Apr 21, 2004
    What do you guys think about sending a fullsize Glock slide to a gunsmith such as Hunter Customs or Heinie to have ths slide modified to look like a Sig 229 or HK USP slide? It could be done i'm sure, but is the slide wide enough to make such a modification or is there not enough metal to take away from? I wouldn't want to have too much metal removed and decrease the strength of the slide. But i do think it would look pretty badass to have a Glock 20 or 21 with a slide that looked similar to the USP's slide. What do you guys think?
     
  2. Custom Glock Racing

    Custom Glock Racing I did it first. Millennium Member

    Messages:
    3,027
    Likes Received:
    12
    Joined:
    Feb 8, 1999
    Location:
    Arizona
    I doubt it can be done and all I can think of is why?
     

  3. Nelybarg

    Nelybarg NC Glocker 30

    Messages:
    268
    Likes Received:
    0
    Joined:
    Jul 14, 2002
    Location:
    NC
    lamest idea i've heard this week. you're off to a good start. if you want a sig or a H&K then buy one of them. dont ruin a perfectly good Glock just to mimic some other gun.
     
  4. Tspeis

    Tspeis

    Messages:
    37
    Likes Received:
    0
    Joined:
    Apr 21, 2004
    It's not something huge, i just think it would look pretty cool on a Glock.
     
  5. WalterGA

    WalterGA Millennium Member

    Messages:
    3,742
    Likes Received:
    0
    Joined:
    Jan 26, 1999
    Hard to argue with that logic!