# Glock pin punch decimal equivalant?

Discussion in 'General Glocking' started by Oak, Jan 17, 2006.

1. ### Oak

Messages:
65
0
Joined:
Feb 3, 2002
Location:
midcoast, Maine
I'd like to make a punch for the pins for my G19 out of a small screwdriver. Can someone give me the decimal equivalant of 3/32 so that I can use a micrometer to measure the diameter as I grind?

Thanks,
Oak

2. ### PSU_G34London Calling

Messages:
156
0
Joined:
Feb 5, 2004
Location:
ID
3/32" = 0.09375" = 2.38mm

JMO, but since the trigger pin is plastic, just buy the right punch for the job.

3. ### WIG19Light left on

Messages:
3,785
0
Joined:
Oct 27, 2003
Location:
1.000 divided by 32 is 0.03125, times 3 is 0.09375

;T

4. ### Oak

Messages:
65
0
Joined:
Feb 3, 2002
Location:
midcoast, Maine
Thanks for the answers. Sorry to have to ask, but my calculator has dead batteries as I found out when I went to do the math myself. It's been a long time since I was able to do that without the electronic brain. I want to get to work on this tonight.

Oak

5. ### ERASERNyuk,Nyuk,Nyuk!

Messages:
5,310
1,101
Joined:
Jan 23, 2000
You can use an Allen key, too.

6. ### T. Harless

Messages:
930
1
Joined:
Jan 14, 2003
Location:
WV
Oh it is not plastic.
Still I'd just pony up the \$6 and buy the Glock one. Cool factor yo. That said, I cut a chunk of stout cloths hanger wire, bent an eye on the end and keep it on my key ring. Works just fine.

7. ### PSU_G34London Calling

Messages:
156
0
Joined:
Feb 5, 2004
Location:
ID
Oh it is plastic.

We are talking about the trigger housing pin right?

8. ### T. Harless

Messages:
930
1
Joined:
Jan 14, 2003
Location:
WV
No, when you said "....but since the trigger pin is plastic..." I'd have to assume we're talking about the Trigger pin, which is not plastic.

Messages:
156