Glock Talk banner

Glock perfection? G41

504 2
Hmm . . . dont think so this time. I just obtained a new G41 and during close inspection, I found a few bizarre quirks about this gun that I never had in my gen1 G19 or gen4 G23.

The slide is at an angle and there is a HUGE gap between the slide and frame (at the slide release area) that is wide enough to slip a dime in, almost a penny. The gap is too wide. This is to be a woods gun but if so it will collect so much grit, dirt and crap inside it might be unreliable.

The odd thing is that during slide reassembly, that prong hits the backplate and I must lift that slide substantially in order to get it assembled.
Have any of y'all had this problem? I am not going to even shoot this gun and have contacted Glock.

Attachments

Top