Glock Talk banner
1 - 1 of 1 Posts

· Registered
77 Posts
Discussion Starter · #1 · (Edited)

I have orderd a silencer to a LWD 9mm barrel and the threading is ½-28.
In USA that is standard but here in europe is not so the company will special make it for me and now they asked me:
is there end inlet in the barrel, below thread? I mean below the
thread, how is the thread ended? Silencer manufacturer
needs to know it. If you have better picture of the barrel threaring it
would help. To make the best silencer
this information is valuable. This is not seen the linked barrel you
sent earlier.

I dont know the answer so now im asking you if you know or if you can send me a photo of the threading(LWD 9mm Threading) to my email: mmd_bbk (at)

Thank you
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.