close

Privacy guaranteed - Your email is not shared with anyone.

Glock 34 front sight

Discussion in 'General Glocking' started by CarlosDJackal, Sep 30, 2004.

Tags:
  1. CarlosDJackal

    CarlosDJackal

    Messages:
    1,386
    Likes Received:
    0
    Joined:
    Dec 10, 2000
    I am trying to figure out how I am going to be able to install night sights on my Glock 34 when I can't even get my front sight tool to fit that little hole to screw it in. My Glock 35's hole is a lot larger so it was not a problem at all.

    Anyone have any ideas?
     
  2. 4eyes

    4eyes Provocateur

    Messages:
    1,263
    Likes Received:
    0
    Joined:
    Dec 20, 2003
    Location:
    redneck heaven
    Yep. If your sight nut tool is a 3/16ths socket, grind it to a smaller diameter to fit the hole.
     

  3. DJ Niner

    DJ Niner Moderator

    Messages:
    16,904
    Likes Received:
    2,678
    Joined:
    Feb 13, 2001
    Location:
    North-Central USA
    I went to a pawn shop that had a lot of used tools, and bought a handful of cheap 3/16ths nutdrivers, complete with handles. Then I modified them by thinning the sides and reducing the bottom taper so they would reliably grab those thin little hex-head nuts used on the night sights.

    A buck apiece and an hour of my time; I still have two of them laying around, the others I donated to folks who needed them.