Glock Forum - GlockTalk banner
1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Hi guys,

I am doing a P80 build. Everything has worked so far except I cannot get the slide fully into battery. I am hanging up on the locking block and the barrel lug. A factory barrel fits into the build just fine. I didnt have calipers with me to measure the dimensions when I had the factory barrel.

Anyone out there have a factory G34 barrel that can take these measurements?

Product Electronics Technology Diagram Auto part
 

·
Registered
Joined
·
2 Posts
Discussion Starter · #2 ·
Hi everyone. I was able to measure a factory G34 barrel. Just incase anyone else needs to know what they are I am posting them
Product Diagram Line Auto part Technology
.

1. 20.5mm
2. 22.37
3. 24.30
4. 15.16
5. 20.56
6. 34.11
7. 30.97

*disclaimer I measured a rental guns barrel, no clue how warn it was. I took off a tiny bit off of measurement # 3 and thats all it took.

The parts I have been working on for the build are a POF P40 Warhawk slide, P80 PFS9 lower, and and Agency Arms Barrel.

883608
 
1 - 2 of 2 Posts
Top