Privacy guaranteed - Your email is not shared with anyone.

Glock 32 FTL problem

Discussion in 'General Glocking' started by JerForceOne, Dec 20, 2010.

  1. JerForceOne


    Aug 8, 2010
    Likes Received:
    I watched a video on youtube about some problems with the loaders and or mags for the glock 32. I had hoped that since i bought my glock 32 a while after that video was shot the problem would have been fixed by now.

    Unfortunately when i took it to the range today I had quite a few failure to load issues. Below are the specifics...

    - I have 4 clips, 1 is stamped with a "1" and the other 3 are stamped with a "2".
    - I had 6 or 7 FTLs on the one stamped "1" and a couple on one of the ones stamped with a "2". My other two "2's" shot fine and had no FTLs.
    - I used 3 different brands of ammo today: Fiocchi, Speer Lawman, and Winchester white box. I had FTLs on all 3 brands.
    - I shot the same amount of ammo and the same brands out of my Sig p229 .357 with no FTLs

    So, my question is, Could it be the mags? Or could it be something else? What is usually the cause for a FTL issue?

    Any advice would be great.
  2. JR

    JR Moderator Millennium Member

    Dec 29, 1998
    Likes Received:
    Oldtown Idaho USA
    The 357 follower marked 357/10&1 is intended for use in 10 round magazines.
    The 357 follower marked .357 & 2 is the current follower for 9/11/13/15 round magazines.

    Try upgrading followers to current issue.