close

Privacy guaranteed - Your email is not shared with anyone.

Glock 22 grip reduction to match 23

Discussion in 'General Glocking' started by cowboyarcher, Apr 9, 2012.

  1. cowboyarcher

    cowboyarcher

    Messages:
    43
    Likes Received:
    0
    Joined:
    May 15, 2010
    Location:
    Wyoming
    Has anyone noticed that the finger grooves on the 22's are larger than those on the 23's and 27's?

    I happen to have small hands and the 23 grooves fit much better, but I have a 22 and not a 23. I'm wondering if it is possible to remove the 22's finger grooves and then remold some material to match the 23's grooves. I also have a 27 and would like the grips to be more similar. . .

    Thanks!

    Adam
     
  2. TSAX

    TSAX USAF Vet

    Messages:
    10,162
    Likes Received:
    7
    Joined:
    Jun 5, 2010

  3. cowboyarcher

    cowboyarcher

    Messages:
    43
    Likes Received:
    0
    Joined:
    May 15, 2010
    Location:
    Wyoming
    Maybe it would be better to call what I'm after a "finger groove relocation"??
     
  4. ImpeachObama

    ImpeachObama Fuhgettaboutit

    Messages:
    969
    Likes Received:
    14
    Joined:
    Dec 31, 2010
    Location:
    Fuhgettaboutit
    How about leaving the finger grooves alone and reduce the size of the palm swell on the backside of the grip? Here's a reasonable idea that I am presently undertaking, although I am not going to stipple it like him. I am going to use Talon grip like on my other models. I too am doing the G22. I didn't drill thru to the mag cavity wall. I just put two holes thru from the grip into the empty well.

    [ame="http://www.youtube.com/watch?v=TbJbY-oOP1g"]Glock Grip Reduction Part 1 - YouTube[/ame]