close

Privacy guaranteed - Your email is not shared with anyone.

Glock 17 FTE

Discussion in 'General Glocking' started by MustangDaddy, May 31, 2011.

Tags:
  1. MustangDaddy

    MustangDaddy

    Joined:
    Aug 3, 2005
    Messages:
    24
    Likes Received:
    0
    Location:
    Nevada
    Hey all,

    I have a Gen2 Glock 17 that I recently picked up. I have 400rds through it and have had 14 failure to ejects at various stages in firing. I have swapped out the recoil spring/guide rod and the mags but still get them. I have been carrying and shooting glocks on and off duty for 20yrs and have never....ever had this problem. Any idea's??? Maybe the extractor needs attention now?? Thanks in advance for any input! :)
     
  2. JR

    JR Moderator Millennium Member

    Joined:
    Dec 29, 1998
    Messages:
    3,054
    Likes Received:
    2
    Location:
    Oldtown Idaho USA
    The best way to inspect your extractor is to remove the top end from the frame. Remove the recoil .spring and barrel. Now look over the extractor from the under side. You will instantly identify any problem from this vantage point
     

  3. MustangDaddy

    MustangDaddy

    Joined:
    Aug 3, 2005
    Messages:
    24
    Likes Received:
    0
    Location:
    Nevada
    Fixed! Took it to my gun dealer and had it looked over. Upon removing the extractor it became obvious. The back side of the little lip was broken off completely. New extractor installed and back to normal Glock mode! Considering the amount of metal lost I am pleased that it still functioned as well as it did all things considered! :wow:

    Thanks for the input!
     
  4. JR

    JR Moderator Millennium Member

    Joined:
    Dec 29, 1998
    Messages:
    3,054
    Likes Received:
    2
    Location:
    Oldtown Idaho USA
    Too bad you didn't look it over the way I explained. You can easily spot the problem from the under side. This way you would be able to diagnose the issue for yourself and show other shooters how to do the same.
     
  5. MustangDaddy

    MustangDaddy

    Joined:
    Aug 3, 2005
    Messages:
    24
    Likes Received:
    0
    Location:
    Nevada
    I did look the way you suggested. It appeared that all was ok with the extractor. There was literally almost no gap between the lip and the breech face, making it hard to see anything. It wasnt until the extractor was removed that the missing metal was seen. There was metal lip on the front side of the extractor but most all of it was missing from the backside of it....kinda odd!
    With the new extractor in place there is a much more visible gap between the lip and breech face. Now she's running like a champ again. :cool:

    Thanks again for the input.