Glock Forum - GlockTalk banner
1 - 5 of 5 Posts

·
Registered
Joined
·
318 Posts
Discussion Starter · #1 ·
My 41 is a "red label" that indicates a 4.5 connector. I want to replace it with a 5.5 connector. I have a bag full of Gen 3 (9MM/40) 5.5 connectors. Is this the correct connector for the Gen 4 41 or do I need a different part?
 

·
Registered
Joined
·
2,649 Posts
Red label Gen4 should have a dot connector that has a . on the back. This is the standard 5.5lb. A minus connector “-“ is 4.5lbs.

The Gen3 connector will result in a heavier trigger pull on a Gen4 than it does on a Gen3. It will still function, it’s just heavier than the Gen3 due to the trigger mechanism putting the connector at a slightly different angle.
 

·
Registered
Joined
·
2,649 Posts
Send me a PM with your address, I’ll send you one.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top