Glock Talk banner

G42 Reassembly

683 Views 6 Replies 6 Participants Last post by  Mike-M
Just picked up me new 42 and put 200 rounds through. I did a complete teardown and cleaned her up. I have a couple of questions on the reassembly. 1)the plastic piece that resides inside the trigger spring has a slanted side and a flat side. Mine has the flat side up. Is that correct. 2) are the slide lock spring and the firing pin safety spring the exact same spring or do I need to keep track of which one goes where. 3)Does the slide lock notch face the rear like it's big brothers.
I always appreciate the help.
1 - 1 of 1 Posts
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.