Glock Talk banner

G20 10MM extractor question.

1059 Views 15 Replies 5 Participants Last post by  GRR
I bought this 10mm and the extractor looks different in the gun than my other Glocks.
Does this look normal?
Electronic device Computer accessory Laptop accessory Personal computer hardware Computer hardware
Electronic device Red Technology Pink Magenta
  • Like
Reactions: bigjoepa
1 - 16 of 16 Posts

· Registered
Joined
·
3,966 Posts
Looks like it might be sitting too deep. Probably a 40 extractor. The extractor on my 21 is flush with the outside of the slide. It does appear to be a 15 degree non-LCI extractor though.
 

· Registered
Joined
·
3,252 Posts
Looks like some aftermarket work was done on the pistol, so did the previous owner give you any info as far as work done?

You might want to get some parts if you don't have any info. Both old and new style extractors are available here at Glockparts, second row down. Also check the Extractor Depressor Plunger and Spring Loaded Bearing. Also on that link page 1 and 2. Problem you will have is to re-coat the new extractor if needed.
http://glockparts.com/Products.aspx?CAT=708

Dave
 

· Registered
Joined
·
3,966 Posts
1 - 16 of 16 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top