close

Privacy guaranteed - Your email is not shared with anyone.

G19 Conversion Question

Discussion in 'General Glocking' started by Timor, Apr 5, 2010.

  1. Timor

    Timor

    Joined:
    Oct 2, 2000
    Messages:
    142
    Likes Received:
    1
    Location:
    Near Raleigh, NC
    Hello all,

    I purchased a Glock 19 3rd Gen (three pin) a few months ago.

    I had the grip frame modified by Cold Bore Customs in Katy Tx, who did a magnificent job.

    More recently I traded for a 3rd gen Glock 32. It came with a Lone Wolf 9mm conversion barrel. I really like the versatility of two calibers in one gun, however I want the grip mod done to my G19 without dropping another $200.

    Can I put the G32 upper on my G19 lower?

    Someone on another forum said that all I would have to do is install a G32 ejector since both are three pin models.

    Someone else suggested I pose the question here so here I am.

    Thanks for any and all assistance.

    Tim
     
  2. JR

    JR Moderator Millennium Member

    Joined:
    Dec 29, 1998
    Messages:
    3,057
    Likes Received:
    2
    Location:
    Oldtown Idaho USA
    If your G19 frame is a 3rd gen you can put the 32 upper on it. You will also need to change the trigger housing from a 9mm to a 40/357.
    FYI: The trigger housing included the ejector. Glock does not offer the ejector alone. It must be purchased with a trigger housing.
     

  3. Timor

    Timor

    Joined:
    Oct 2, 2000
    Messages:
    142
    Likes Received:
    1
    Location:
    Near Raleigh, NC
    Thanks JR, for the information.

    I'll be putting in an order with Lone Wolf as soon as you get more of your G23 barrels in stock.

    Tim