Glock Talk banner
1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Pic is linked.


I'm pretty good at taking a Glock apart except today was my first time doing the mag release and takedown lever. Very slightly bent the takedown spring but i bent it back (really not much, the last 2 coils were on a 15-degree angle)

Went to put the gun back together and the picture is what I'm left with...

DO I need a new takedown lever spring or did I do something else? I took it all back apart and nothing seemed weird.

Thanks.


Edit: The takedown spring has plenty of pressure, is the same length as it was from the factory, and rides smoothly up and down in its channel... WTF. I think the issue is the recoil spring not holding down the barrel, but what could be causing this.?
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top