I have an Uncle Mike's paddle holster made for the 9/40/357 XDs. Right-handed and lightly used. $14 out-the-door price. PM me if you want a pic, but just look at the pic on Uncle Mike's website. PRICE REDUCED ! ! ! $14.00 ! ! ! I have High Noon's Sky High holster made for the Glock 34/35. Thumb-break, right-handed, lined (click here for details), FBI-canted, with belt slots made for 1.5-inch belts. The bottom of the holster is semi closed so you couldn't fit the Glock 17L/24 in it. After I bought it from them in the mail (took 6 months) I tried to break it in but I couldn't. So I sent it back to the company so they could break it in. A week later I received it. It was a little easier to fit my Glock in, but it still wasn't broken in enough for me. I noticed that there was a 4-inch crease on the front of the holster, running parallel to the boning crease of the holster where the top of the slide is molded. It was not there before I sent it back. You can only see it under a bright light. Otherwise, you will not notice it under normal lighting conditions. I concluded that whoever tried to break it in at the factory put that crease in the holster. If I get a few PMs from folks wanting to see it, I suppose I can post it if the picture I take brings it out. In any case, it is a superb holster that costs me about $98.00 and six months wait time. PRICE REDUCED TO $68.00 ! ! ! This is the IWBT holster below from Concealco made for the Glock 19/23/32. Right-handed, thumb-break, and FBI-canted. Only been worn twice in my house. More info can be found here. I will give it up for $57.00 total price. The pictured gun is NOT included.