Separate names with a comma.
Discussion in 'Sights, Optics and Lasers/Lights' started by ninjag19, Jan 31, 2013.
On the G19 gen 4,what is the proper size socket to remove the front site? Thanks!
3/16, has to be very thin walled.
Ok thanks for the quick reply!
As stated, 3/16. A VERY thin walled nut driver is needed.
I used one of these and it works great: [ame="http://www.amazon.com/dp/B000O5ILUM/ref=pe_175190_21431760_3p_M3T1_ST1_dp_1"]Wiha 26547 Precision Nut Driver, Inch, 3/16 x 60mm - [email protected]@[email protected]@http://ecx.images-amazon.com/images/I/[email protected]@[email protected]@21iKdD-oFjL[/ame]
Here is an even quicker reply:
When you purchase the Pyramid sight from ATS they send you a small wrench.
Hi-Viz make a good one http://www.hivizsights.com/products/handgun-sights/glock/glock-tl.html
That's cool, but since I have a lot of sockets around, I will probably take one to the grinder! lol