close

Privacy guaranteed - Your email is not shared with anyone.

Does the Mini DRACO use a Shepherd's Crook?

Discussion in 'General Firearms Forum' started by Steel & Wood, Jul 8, 2013.

  1. Steel & Wood

    Steel & Wood Build the Wall

    Joined:
    Jul 14, 2006
    Messages:
    8,421
    Likes Received:
    691
    Location:
    Where English and NYer's Go to Die!
    Mine does NOT have one......should it?

    Thanks,


    TGG
     
  2. spec357

    spec357

    Joined:
    Jan 6, 2012
    Messages:
    139
    Likes Received:
    1
    Location:
    Pa.
    Do you mean the piece that holds the trigger group in place? I never owned a draco but my WASR 10-63 had one of those in it and it wasn't holding everything in right. First thing I changed out on the rifle. I put one of the flat plates in and haven't had a problem since. So if you have a plate holding it together in my opinion you are much better off.
     

  3. Steel & Wood

    Steel & Wood Build the Wall

    Joined:
    Jul 14, 2006
    Messages:
    8,421
    Likes Received:
    691
    Location:
    Where English and NYer's Go to Die!
    Correct. I do see a wire (NO plate) but it is going UNDER the pins and is not held in by the safety lever:dunno:

    The pins do NOT come out though, so I guess it's working.

    On my WASR- 10/63 the wire hooks onto the hammer pin but does NOT touch the trigger pin before angling up toward the safety lever.

    It's all good though because I have two RETAINING PLATES coming in the mail on Thursday:cool: Hopefully they will install easily and this headache will be over.

    Thanks for the input :thumbsup:


    TGG