Glock Talk banner
1 - 4 of 4 Posts

·
I.C.P.
Joined
·
9,429 Posts
Discussion Starter · #1 ·
I have a NHM91 that I was thinking about doing a chop and hack on. It's the 20 inch heavy barrel and I was thinking about shorting it and have a perm hider installed so I could get it as short as possible without going NFA on it.

I know the Chinese guns are great shooters and I know that the NHM91 has a little collector value. But I didn't get the bipod or anything because I got it in a trade with a friend.

Think this is a good candidate for some work or should I just sell it and buy something else to chop on.
 

·
I.C.P.
Joined
·
9,429 Posts
Discussion Starter · #7 ·
Additionaly thought, by altering the barrel length, will you need to open up the port in the barrel to make it feed correctly?
Not sure if I would have to open the port or not. If I did this I was going to send it to someone who knows what they are doing........ I have a dremal........but I don't use it on parts that could kill me.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top