close

Privacy guaranteed - Your email is not shared with anyone.

Can't get trigger to break, Can't get slide released

Discussion in 'General Glocking' started by rlanesmith, Oct 10, 2010.

  1. rlanesmith

    rlanesmith

    Joined:
    Jun 28, 2010
    Messages:
    14
    Likes Received:
    0
    Location:
    Myrtle Beach, SC
    I put my Gen4 together yesterday after working on the trigger (overworking probably). Now I can't get the trigger to cock, can't break it and therefore can't get the slide off. Help!
     
  2. JR

    JR Moderator Millennium Member

    Joined:
    Dec 29, 1998
    Messages:
    3,054
    Likes Received:
    2
    Location:
    Oldtown Idaho USA
    Make sure the gun is empty.
    Insert your Armorers tool in the rear of the slide through the large notch in the slide cover plate.
    Aim the tool towards the top of the slide and push it 1/2 way in. At the 1/2 way point direct the tool downward. You will feel the trigger bar drop the connector.
    Disassemble as usual.
     

  3. rlanesmith

    rlanesmith

    Joined:
    Jun 28, 2010
    Messages:
    14
    Likes Received:
    0
    Location:
    Myrtle Beach, SC
    Bingo! Have learned something. Thanks, JR