Separate names with a comma.
Discussion in 'General Glocking' started by SCHOOFSTER, Jun 10, 2020.
Had to say goodbye to that horrendous RTF texture on my Gen 3 G19. I have a video but it won't post.
You're braver than I! I would definitely screw up with a dremel in my hands!
Are you going to leave it "naked" or add some kind of grip tape/sleeve?
Good job, but I would have just traded the frame to someone looking for that roughness specifically.
Is it a RTF2 with a slide that has the crescent shaped (gills)?
Noooooooooo! It's my favorite grip pattern!
Had a G23 RTF once, hated that thing.
I would have used a Talon grip, but its your Glock, and its permanent now eh?
I'd like to see the end results too, if you don't mind.
So now what is the plan? Are you going to stipple it? Leave it bare?
There are some who love the RTF2. You probably could have swapped for one, and perhaps got a little money as part of the deal. I hope you enjoy the end result, whatever than may be.
Whatever. It definitely has a much much lower market value now.
There are far more intelligent ways to relieve the aggressiveness of the early RTF grip texture.
Ha, poor dude shares his changes with the forum.... and everyone is doggin' him!
though.... I could see it coming a mile away, ha!
his hog his corn
Lol. It's a $100 dollar Glock frame. There is no added value. I bought 6 of these.
Can I call you an ambulance??
If you didn't like it why did you buy it?
I would have gladly given/traded you, the 'dime a dozen' standard G3 frames
BULL CRAP. I m calling BS.
Glock RTF2 frames are $175-$250
Stupid is as stupid does. Go ahead and take a knee as well.
Oh I didn't do the work. Lol. I'm not that good
I knew what I was doing when I posted this. Lol. Got the results I expected
Lol. Ok. Maybe where you get them.