Breech face wear on a new G19

Discussion in 'General Glocking' started by winkel, Oct 9, 2020.

  1. harold63

    harold63 I'm not retired

    Messages:
    7,145
    Likes Received:
    3,629
    Joined:
    Nov 25, 2014
    Location:
    SW Florida
    What's the fun in that. We'd never see that they can actually not be perfect.
     
  2. harold63

    harold63 I'm not retired

    Messages:
    7,145
    Likes Received:
    3,629
    Joined:
    Nov 25, 2014
    Location:
    SW Florida
    I'm not a Taurus fan. I'm not a fan of anything, really. I buy what I like and if it works, I buy it, again. I don't judge or take sides. I consider myself one lucky somebich.
     

  3. alhovde

    alhovde

    Messages:
    76
    Likes Received:
    114
    Joined:
    May 6, 2010
    There's nothing fancy about GD&T. You could probably find the entire standard published online for free. ASME Y14.5-2009 is used ubiquitously in all industries from automotive to aerospace. I would challenge you to check it out (rather than going back and forth). After which, if you still think the barrel or slide is out of spec, then we can agree to disagree.

    I am resisting the urge to draw a sketch to demonstrate how both parts can be within very tight tolerances and show one sided wear at the interface.

    OP: Your Glock is good to go! If you are still concerned follow up with Glock CS directly. They'll say the same thing.
     
    Papa glock likes this.