Glock Forum - GlockTalk banner
1 - 6 of 6 Posts

·
Registered
Joined
·
1,026 Posts
Discussion Starter · #1 ·
So after selling my Gen 3 G29, I finally picked up a G20sf on gallery of guns. I am not a small guy, but I had a hard time accurately shooting the g29 with hunting loads, even with pinky extensions and mag-na-port. Been wanting a G20 for a long time, so looking forward to shooting this one with all the stockpiled 10mm ammo I have laying around. Not going to mod the heck out of it either, just 3.5 lb trigger bar, .25 cent polish job, and extended slide release and take down lever. I'll post some boring pics of it when I get it.
 

·
Super Moderator
Joined
·
4,057 Posts
Same boat here. I changed the sights to a target rear and FO front, 3.5# connector, XP trigger spring and a LW overtravel stop. Shoots like a dream.

My G20sf sitting with my QC10 lower, 610 and Razorback.
Firearm Gun Trigger Airsoft gun Gun accessory
 

·
Registered
Joined
·
1,026 Posts
Discussion Starter · #6 · (Edited)
Ok, as promised, here are some boring pics of my new G20SF. Did a .25 cent trigger job on it and installed a double diamond 3.5# connector, extended slide stop release, and take down latch, and the trigger is just the way I like it. Can't wait to go out and shoot it.
 

Attachments

1 - 6 of 6 Posts
Top