Glock Talk banner
1 - 1 of 1 Posts

· Registered
Joined
·
170 Posts
Both of my Gen 5 guns (17 and 19) show similar marks. The 19 has about 1500 rounds and the 17 is a little over 1000. To me, it just looks like a finish wear issue. I also noticed on both slides where the wear is, the surface appears to be slightly raised. You can see it has a lower edge to it. I don’t know if previous generations had the same raised surface; I’ve only owned Gen 5 pistols.

G17 (~1000rds):


G19 (~1500rds). This slide was refinished (nitrided) when I had the optic cut done. All the rounds fired were after the refinish.



Sent from my iPhone using Tapatalk
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top