Glock Forum - GlockTalk banner

1 - 6 of 6 Posts

·
Registered
Joined
·
652 Posts
Discussion Starter · #1 ·
I would like to shoot 9mm out of my Mod 37 45 Gap. I would need a 9mm barrel, magazine and possibly a new recoil spring. What else might I need for the conversion to work? Thanks in advance.
 

·
Registered
Joined
·
2,152 Posts
..... What else might I need for the conversion to work? Thanks in advance.
a new slide.

I've had a 37 for several years and to the best of my knowledge, no one makes a 9 mm conversion barrel for the 45 Gap.

at one time, there was a 40 S&W conversion barrel but I didn't look into it and don't know if there still available.

I have run my 37 frame with a 31 slide, an after market 40 to 9 conversion barrel and 17 mags so it is do-able, but not with a stock slide.

as a side note, I've never fired a factory round in my 37, just my reloads, for the cost of a new slide, you could probably get a reloading set up for 45 Gap, once you have equipment and components, it all about finding the time to reload.

https://kempfgunshop.com/Kempf_Kit_w/_Lee_Classic_Turret_Press_-90064Kit-6575.html

P.S. - just don't buy 45 ACP dies.
 

·
Senior Member
Joined
·
909 Posts
ATI and I think Lonewolf used to make a 45 gap to 40SW conversion at one time

OOps 357sig fan already covered this
My bad
 
1 - 6 of 6 Posts
Top